27
Programming Reference
Agilent 81101A SCPI Command Summary
:OUTPut[1]
[:NORMal]
[:STATe] OFF|ON|1|0 Set/read normal output state
:IMPedance 47
[:INTernal] <value> Set/read internal source impedance of
output
:EXTernal <value> Set/read expected externa l load imped-
ance at output
47
:POLarity NORM|INV Set/read outp ut polarity 48
[:SOURce]
:CURRent[1]
[:LEVel]
[:IMMediate]
[:AMPLitude] <value> Set/read channel amplitude current 48
:OFFSet <value> Set/read channel offse t current 49
:HIGH <value> Set/read channel high level current 50
:LOW <value> Set/read channel low level current 51
:LIMit
[:HIGH] Set/read maximum current limits 52
:LOW Set/read minimum current limits 53
:STATe ON|OFF|1|0 Enable/Disable the current limits 53
:FREQency
[:CW | :FIXed] <value> Set/read frequency of pulses 54
:AUTO ONCE Measure frequency at CLK-IN 55
:HOLD[1] VOLT|CURR Switch between V OLtage and CURRent
command subtrees
55
:PHASe[1]
[:ADJust] <value> Set/read channel p hase 56
:PULSe
:DCYCLe[1] <value> Set/read channel d uty cycle 57
:DELay[1] <value> Set/read channel dela y (to leading edge) 57
:HOLD TIME|PRATio Hold absolute delay|phase delay fixed
with varying frequency
58
:UNIT S|SEC|PCT|DEG|RAD Set/read delay units 59
Command Parameter Description
see
page