Agilent Technologies 81101A Trigger Modes

100

Specifications

Agilent 81101A Specifications

Trigger Modes

Continuous

Generate continuous pulses, double pulses, or bursts.

Externally Triggered

Each active input transition (rising, falling or both) triggers a single

pulse, a double pulse, or a burst.

The trigger source can be selected from:

• External Input

• MAN Trigger key

• internal PLL.

Externally Gated

The active input level (high or low) enables pulses, double pulses, or

bursts. The last pulse, double pulse, or burst is always completed. The

gate source can be selected from:

• External Input

• MAN Trigger key

External Width

To recover a pulse shape of an external signal, applied to the External

Input, the period and width are maintained, levels and transitions can be

set.

Contents

Main MODIFY Front Panel Display and Softkeys Page Notice Copyright Notice Warra nty Limitation of Warranty Exclusive Remedies Certification Services and Support Safety Summary General Environmental Conditions Before Applying Power Ground the Instrument Fuses Do Not Operate in an Explosive Atmosphere Do Not Remove the Instrument Cover Safety Symbols About this Book Conventions Used in this Book Page Contents Page The GP-IB Interface Bus Agilent 81101A Remote Control Programming Recommendations Page Common Command Summary 19 General Programming Aspects Status Model Status Model Condition Register Transition Filters Event Register Enable Register Status Byte Standard Event Status Group OPERation Status Group QUEStionable Status Group 2 Agilent 81101A SCPI Command Summary Page Page Page Page Default Values, Standard Settings Page Page Page Programming the Instrument Trigger Modes Continuous Triggered Gated External Width Pulses Burst SCPI Instrument Command List Page Page Page Page Page Page Page Page Page Page Offset = High Low Page Page Page Page Period = 1 Frequency Page D elay = Phase 360 Period Width = Duty Cycle 100 Period Phase = Delay Period Delay% = Delay Period Page Page DblDel% = DblDel Period Page Frequency = 1 Page Page Page Page Page Page Page High = Offset + Amplitude Low = Offset Amplitude High = Offset + Amplitude Low = Offset Amplitude Page HighLow Offset = Page Page Page 77 5. :STATus:QUEStionable:PTRansition 4. :STATus:QUEStionable:NTRansition Page Page Page Page Page Page Page Page Page Page Page 3 90 Specifications Declaration of Conformity Declaration of Conformity Manufacturer Safety EMC Supplementary Information Agilent 81101A Specifications General Page Timing Specifications Period Glitch-free timing changes Width Delay Double Pulse Delay Transition Times Level Specifications External Load compensation Level Parameters Pulse Performance Clock Sources Clock / PLL Reference Input Phase Locked Loop (PLL) External Clock Output Modes Pulses Mode Burst Mode Trigger Modes 101 Specifications Agilent 81101A Specifications Trigger and Strobe Specifications Trigger Output Strobe Output Typical Delays Human Interface Memory Remote Control Pulse Parameter Definitions Time Reference Point Pulse Period Trigger Delay Pulse Width Pulse Delay Double Pulse Delay Interchannel Delay (Skew) Transition Time Linearity Jitter Stability Pulse Levels Preshoot, Overshoot, Ringing Settling Time Page Page Page Page Page Page Front Panel Controls Page MANUAL CHANGES September, 01 Page Page Page