Aiwa Z-L31 2,4, 20 ENGLISH, Press TIMER, Preparation, that 0 disappears, “VOLO“is displayed, Carry out from step, 3 Play the turntable, To check the timer setting

To check the timer settingPress TIMER.

The selected source, the timer-on time, and the duration for the timer-activated period will be displayed for 4 seconds.

To change any of the previous settingCarry out from step 1.

However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4.

To cancel the timer standby mode temporarily Press TIMER so that 0 disappears.To restore the timer standby mode, press TIMER again to display 0.Using the unit while the timer is set

You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6.

●Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

(\.-–-—– .– ‘i

2,4

Preparation

●Connect the supplied stereo turntable to the main unit. (See page 4)

●Set EQUALIZER AMP. selector on the turntable to ON position. (Refer to the operating instructions of the turntable for details.)

1Press PHONO on the main unit.“PHONO”appears on the display.2 Adjust the volume to minimum.Turn VOLUME counterclockwise until “VOLO“is displayed.3 Play the turntable.Refer to the operating instructions of the turntable for details.4 Adjust the volume according to your preference.

20 ENGLISH