MONITOR SECTION 21

MONITOR SECTION
Directly above the MASTER section is the MONITOR section:
The functions are (from top to bottom):
MONITOR LEVEL Sets the level of the signal appearing at the MAIN or NEARFIELD
monitor outputs.
!!! SOLO !!! This LED flashes whenever a channel is solo'd.
Although the channel's ON key flashes when it is solo'd making it
perfectly obvious which channel is being solo'd, it is possible that a
different FADER BANK may be selected and so the solo'd channel
may not be visible (for example, Input 5 may be solo'd but the current
FADER BANK might be, say, Tracks 1-12). As a result, it may not be
clear that a channel is solo'd. This 'master' SOLO LED helps over-
come this by showing that a channel somewhere is solo'd.
2-TRACK This switches the 2-TRACK input into the main monitor output, over-
riding the main L/R mix. Normally, this will be used to check the
output of an external stereo recorder/player. However , the 2-TRACK
switch exists only on the monitor output and it does not affect the
master stereo L/R output.
By default, the stereo 2-TRACK input is the source for this, but it is
also possible to route the stereo AUX IN or the stereo DIGITAL IN
instead in the SETUP mode.
v1.6 Operator’s Manual