Alamo 1900 manual Lubrication Information, General

(SPRM-1)

MAINTENANCE

PARTS INFORMATION

PARTS INFORMATION

Rhino mowers use balanced and matched system components for blade carriers, blades, cuttershafts, knives, knife hangers, rollers, drivetrain components, and bearings. These parts are made and tested to Rhino specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The use of “will fit” parts may reduce mower performance, void warranties, and present a safety hazard. Use genuine Rhino mower parts for economy and safety.

SEE YOUR RHINO DEALER

LUBRICATION INFORMATION

General

Refer to the lubrication diagram and grease daily all the points shown.

1.Power take-off shaft - The PTO shaft should be regularly examined to ensure that it is in good condition together with the guards. The universal joints should be greased very sparingly, i.e., one shot a week.

NOTE: Overgreasing a universal joint will blow out the cork or neoprene sealing rings that exclude the dirt from the needle bearing inside.

2.The two halves of the plastic guard should be checked daily to ensure that they can spin freely on the shaft. The nylon slip rings which support the guard on the drive shaft should be lightly greased at weekly intervals.

3.The telescoping drive shaft should be similarly separated and grease applied to the internal shaft at approximately 100 hour intervals.

4.Your Boom uses greased bushings that need lubrication, and with proper lubrication should last the lifetime of the machine.

MAINTENANCE

1900 07/11 Maintenance Section 5-3

©2011 Alamo Group Inc.