ASSEMBLY
REMOVAL FROM TRACTOR
Read carefully before commencing to remove the machine from the tractor.
The order of the following steps must be followed exactly. Disconnecting the top link must be the last operation prior to driving the tractor away from the machine.
Do not operate valve lever or machine controls through the rear cab window while standing on or among linkage components. Always seek assistance.
•Select a firm level site for parking the machine.
•Replace parking legs in their sockets and secure in their lowest position.
•Raise the machine on the tractor linkage until the weight is taken off the stabilizer.
•Remove the lower stabilizer pins.
•Unscrew the lift cylinder hydraulic
•Lower the machine to be ground.
•Extend the arms and place the flail head on the ground at half reach.
•Disengage tractor PTO and remove.
•Disconnect stabilizer bars or loosen check chains as applicable.
•Unbolt the control unit from the mounting pillar, remove from tractor cab and stow the levers or switchbox clear of the ground.
•Disconnect the stabilizer from the tractors top hitch position. Allow the stabilizer to slide along the rail until it contacts the eccentric stops.
•Remove draft link pins and drive tractor away from machine.
1900 07/11 | Assembly Section |
© 2011 Alamo Group Inc.
ASSEMBLY
