MAINTENANCE
CABLES
The cables operate on a push/pull system with the spool centering springs always returning the spool to the neutral position when the handle is released.
Care should be taken during installation and operation to ensure that the cables are not trapped or kinked. Any abrasion or damage to the outer casing should be sealed with plastic insulation tape to avoid moisture penetrating.
No routine adjustment of the cables are necessary as they do not stretch. The threaded collar is correctly adjusted when the lever is in a vertical position in its housing allowing an equal amount of travel in either direction.
On no account should any attempt be made to lubricate the cables which are assembled with a special lubricant during manufacture.
NOTE: Be careful in determining the correct cable connections on both the control unit and the valve in the event of cable replacement.
NOTE: Be careful in determining the correct cable connections on both the control unit and the valve in the event of cable replacement.
PTO GEARBOX
Refill the gearbox after the first initial 50 hours and thereafter yearly or 500 hour intervals. or whichever comes first.
Drainage of the gearbox for an oil change is via the drain plug located on the base of the gearbox. To refill or for ‘topping up’ remove both plugs indicated below and fill gearbox via the filler plug to a point where the oil starts to run from the level plug orifice – replace plugs and tighten securely. Fill with multipurpose gearbox oil P/N 00786250.
STORAGE
If machine is be left standing for an extended period of time, lightly coat the exposed portions of the ram rods with grease. Subsequently, this grease which becomes contaminated with dust and grit should be wiped of before the rams are next moved.
If the machine has to be stored outside, tie a piece of tarpaulin or canvas over the control assembly. Do not use a plastic fertilizer bag which could lead to rapid corrosion.
1900 07/11 | Maintenance Section |
©2011 Alamo Group Inc.
MAINTENANCE
