Alamo RX72 Tractor Requirements and Capabilities, Rops and Seat Belt, Tractor Safety Devices

(SG-7)

OPERATION

3. TRACTOR REQUIREMENTS

The tractor used to operate the mower must have the power capacity to lift, pull, and operate the Power Take Off (PTO) at the mower’s rated speed while traveling at a ground speed between 2 and 5 MPH. Operating the mower with a tractor that does not meet the following requirements may cause tractor or mower damage and be a potential danger to the operator and passersby.

Tractor Requirements and Capabilities

•ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.

•	Tractor Safety Devices	Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•	Tractor Horsepower:	RX60 Mower	RX72 Mower	RX84 Mower
	-Minimum	35 HP	45 HP	Lift 60 HP Pull 30 HP
	-Maximum	90 HP	100 HP	100 HP

•Hitch -Lift Type Mower:

	- Lifting Capacity	1000 lbs.	1200 lbs.	1300 lbs.
	- 3-Point Hitch	CAT I or CAT ll	CAT l or CAT ll	CAT II or CAT III
•	Front End Weight	--------As needed to maintain 20% weight on front axle--------
•	Power Take Off	540 RPM 6-spline	540 RPM 6-Spline	540 RPM 6-Spline or
				1000 RPM 21-Spline

3.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened. Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an authorized dealer. OPS-U- 0003

Operate this Equipment only with a Tractor equipped with an approved roll- over-protective system (ROPS). Always wear seat belts. Serious injury or even death could result from falling off the tractor--particularly during a turnover when the operator could be pinned under the ROPS.

3.2 Tractor Safety Devices

If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor warning signals are obscured.

Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO with the PTO master shield missing or in the raised position. OPS-U- 0004

Tractor Horsepower

RX60/72/84 03/09 Operation Section 4-5

© 2009 Alamo Group Inc.

OPERATION