MAINTENANCE
MAINTENANCE
GEARBOX DISASSEMBLY
1.Remove 6 cover bolts from input shaft bearing housing (2).
2.Tap around circumference of bearing housing (2) to loosen housing and shims. Then pull complete shaft
(6)and housing assembly out of main housing.
3.Remove 4 capscrews (14), break gasket loose (11 & 12), and then remove the bearing retainer cap (18).
4.Output shaft assembly must be removed from main housing by driving or pulling shaft out bottom end. NOTE: Once lower bearing is out of housing the complete assembly will drop.
5.The gearbox is now disassembled into four (4)
1.Input shaft assembly
2.Output shaft assembly
3.Lower bearing retainer assembly
4.Main housing assembly
1.Housing
2.Lockwasher
3.Bolt 4.Input Cap 5.Input Shaft 6.Input Oil Seal 7.Shim (0.30) 8.Shim (0.50) 9.IInput Gasket (0.10) 10.Input Gasket (0.25) 11.Gear Mounting Spacer 12.Output Spacer 13.Output Cap 14.Lockwasher
15.Bolt 16.Cotter Pin 17.Flanged Nut 18.Output Oilseal
19.Output Cap Gasket (0.10) 20.Output Cap Gasket (0.25) 21.Output Shaft 22.Bearing Assembly 23.15 Tooth Gear 24.Bearing Adjusting Nut 25.Cotter Pin
26.Bearing Assembly 27.Drain Plug 28.Sealing Washer 29.Spacer
30.24 Tooth Gear 31.Dip Stick 32.Output Seal Protector
RX60/72/84 03/09 | Maintenance Section |
© 2009 Alamo Group Inc.
