ASSEMBLY
DRIVELINE ATTACHMENT |
| ||
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To |
| ||
ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a |
| ||
shield. Entanglement in rotating shafts can kill. Figure |
| ||
Attach slip clutch end of the driveline to the gearbox |
|
|
|
|
| ||
input shaft securely. Make certain that the slip |
|
|
|
clutch is fully onto the input shaft splines. Tighten |
|
|
|
| |||
the locknuts (2) alternately until they have reached |
|
| ASSEMBLY |
the proper torque. Refer to Torque Chart in the |
|
| |
|
|
| |
Maintenance Section. |
|
|
|
|
|
|
|
|
|
|
|
TONGUE (Pull Type) |
| ||
Insert tongue lugs (4) between mainframe uprights and retain using special pin (16). Insert retaining clip (17) to |
| ||
retain pin. Be sure to install bushing (19) on each side to eliminate side movement. Figure |
| ||
RX60/72/84 03/09 | Assembly Section |
© 2009 Alamo Group Inc.
