Alamo RX72, RX84, RX60, 00785503C manual Table of Contents

Table of Contents

SAFETY SECTION	1-1
General Safety Instructions and Practices	1-2
Operator Safety Instructions and Practices	1-3
Equipment Operation Safety Instructions and Practices	1-5
Connecting or Disconnecting Implement Safety Instructions and Practices	1-10
Transporting Safety Instructions and Practices	1-11
Maintenance and Service Safety Instructions and Practices	1-13
Storage and Parking Safety Instructions and Practices	1-15
Concluding Safety Instructions and Practices	1-15
Decal Location	1-16
Decal Description	1-18
Federal Laws and Regulations	1-25
INTRODUCTION SECTION	2-1
ASSEMBLY SECTION	3-1
DEALER SETUP INSTRUCTIONS	3-2
PULL TYPE (RX84 ONLY) INSTRUCTIONS	3-2
SHIELD ASSEMBLY (All Models)	3-2
TAIL WHEEL INSTALLATION (Model RX60 & RX72)	3-3
TAIL WHEEL INSTALLATION - LIFT TYPE (Model RX84 Only)	3-3
DUAL TAIL WHEEL INSTALLATION - LIFT TYPE (Model RX84 Only)	3-4
A-FRAME INSTALLATION (Quick Hitch) (Model RX60 & RX72)	3-4
A-FRAME INSTALLATION (Model RX60-RX72	3-6
DRIVELINE ATTACHMENT	3-7
TONGUE (Pull Type)	3-7
AXLE ASSEMBLY	3-8
HYDRAULIC OR MANUAL LIFT (Model RX84 Only)	3-8
WHEELS (Model RX84 Only)	3-9

Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will provide protection from thrown objects with proper operation under normal conditions. Deflectors must be maintained in

good repair or replaced after no more than two inches of wear off lower edge.	............................................... 3-9
CHAIN GUARDS (Optional Equipment - All Models)	3-11
HYDRAULIC OR MANUAL LIFT (Model RX84 Only)	3-12
CHECK CHAINS (Extra Equipment)	3-12
OFFSET ADAPTER HITCH (EXTRA EQUIPMENT)	3-13
OPERATION SECTION	4-1
Standard Equipment and Specification	4-3
OPERATOR REQUIREMENTS	4-4
TRACTOR REQUIREMENTS	4-5
ROPS and Seat Belt	4-5
Tractor Safety Devices	4-5
3-Point Hitch	4-6
Front End Weight	4-6
Drawbar-Pull Type Mower	4-7
Power Take Off (PTO)	4-7
GETTING ON AND OFF THE TRACTOR	4-8