MAINTENANCE
STEP 5
Install the Bearing Race into the Main Gear Box Housing.
STEP 6
Install Bearing on the Shaft. On the opposite end of the Shaft, install one .012" and one .020" Gear Adjusting Shims. Install the Gear Spacer and the Gear. Install one .020" thick Gear Adjusting Shim and install the Bearing.
FIGURE 47& 48.
FIGURE 47 | FIGURE 48 |
|
STEP 7
Install the Shaft Assembly into the Main Housing. FIGURE 49. Install the Input Cap and check the gap between the Main Housing and the Input cap to determine the approximate amount of Shims that will be required. Remove the Input Cap and install the Gaskets. Reinstall the Cap and install four Bolts. FIGURE 50.
NOTE! These four Bolts should be installed in every other bolt hole of the Cap When tightening, the second bolt tightened should be 180 degrees away from the first bolt tightened. Check how the Input Shaft turns. When turned, if tight, additional Shims are needed. If loose and the Shaft can be moved from side to side, Shims need to be removed. The correct adjustment of the Input Shaft Bearings is when the Shaft turns freely, but cannot be moved from side to side in the Housing.
FIGURE 49 | FIGURE 50 |
SR20M/SR14M 06/98 | Maintenance Section |
© 2004 Alamo Group Inc. |
|
MAINTENANCE
