Alamo SR20, SR14 manual Assembly, Wing Sections Attachments, Hose Bracket Attachment

ASSEMBLY

ASSEMBLY

WING SECTIONS ATTACHMENTS

While the Center Section is still solidly blocked, attach the Wing Sections (1) in the horizontal plane. Using Hinge Pins (2), attach the Right and Left Wing Sections to the Center Sections.

NOTE: Wing Sections may require slight lifting after the Hinge Pin is started to aid pin installation.

Lock the Wing Sections in place with the Hinge Pins. Insert 5/16" x 1-1/2" bolt (3) and locknut (4) at the end of each of the Hinge Pins and tighten securely. FIGURE 4.

4

1

2

3

FIGURE 4. Wing Sections Attachments

HOSE BRACKET ATTACHMENT

Hose Brackets are attached in the front and rear of the cutter. The Front Hose Bracket (1) attaches to the Hose Bracket Mounting on the right side of the tongue mount (2) with Bolt (3), Washer (4) and Nut (5). The Rear Hose Bracket (6) mounts to the Lower Center Axle Spring Mount (7) with Bolt and Locknut (8) FIGURE 5.

1

63

8 4

2

7

5

	FIGURE 5. Hose Bracket mounting
SR20M/SR14M 10/03	Assembly Section 3-4

© 2004 Alamo Group Inc.