Alamo SR20, SR14 manual Introduction

INTRODUCTION

INTRODUCTION

Note: Single wheels shown are used for row-crop shred- ding

Your SR 20 is a medium-duty Cutter designed primarily for weed and grass control, brush up to 2" diameter, and shredding row crops such as cotton and corn stalks. With proper maintenance as described in this manual, your Cutter will provide you with years of dependable service with a minimum of repairs.

It is recommended that all operators of this implement read this manual or be instructed of its contents as to safety, proper operation, and maintenance before beginning operation.

Your SR 20 has been assembled for operation with a specific tractor PTO input speed, either 540 or 1000 RPM. Should you desire to change PTO input speed, contact your local Servis-Rhino dealer who will assist you in performing the necessary modifications. A different Driveline and set of Gears are required. Refer to the Parts Section for Gearbox details. This machine is designed for use with tractors rated 75HP (56kW) to 100 HP (75kW) for 540 RPM drive and a maximum of 140 HP (105kW) for 1000 RPM drive.

When ordering parts for the Gearboxes and the Drivelines, be sure to specify the PTO speed (540 or 1000 RPM) and the serial number. The serial number is located outside of the right Tongue attaching Plate on the center Mainframe section.

Chain Guards are extra equipment. Deflectors, Driveline Integral Shields and Gearbox Shields are standard equipment and to be used at all times.

To place the warranty into effect, fill out the warranty card in full, giving all the requested information, and mail promptly. Be sure to give the serial number of this Cutter.

SR20M/SR14M 10/03 Introduction Section 2-2

© 2004 Alamo Group Inc.