Alamo SR20, SR14 Assembly, Driveline Yoke, 11/16 Bolt End, Clamping Cone, Driveline Attachment

ASSEMBLY

ASSEMBLY

DRIVELINE ATTACHMENT

Remove Wing Nut holding Divider Gearbox Shield and raise Shield. Remove any tape from Gearbox shafts. Attach the Slipclutch end of the Wing Driveline to the Divider Gearbox. Tighten bolts evenly to their proper torque. FIGURE 19. Attach the clamp yoke end to the Wing Section Gearboxes by sliding the yoke to the splined shaft on the Gearbox and tighten the bolts. Move yoke back and forth to make sure yoke is locked in place. FIGURE 20. Install the Main Driveline with slide collar to the Divider Gearbox by sliding the collar back while attaching the yoke to the splined shaft on the Divider gearbox. Check to make sure it is locked in place.

NOTE: Divider Gearbox Shield must be in place to guard connecting yokes and clutches.

WING DRIVELINE
SLIP CLUTCH END	MAIN DRIVELINE	Figure 20.
FIGURE 19. Wing Driveline Clutch End Attachment		Wing Driveline Clamp Yoke End Attachment

DRIVELINE CLAMP CONE YOKE OPERATING INSTRUCTIONS

Loosen the yoke clamp cone with a 11/16” (17mm) wrench and remove the cone from yoke. Slide yoke onto the shaft and align hole for clamping cone with annular groove of gearbox shaft. Reinstall cone and tighten (75 lb-ft torque). Push and pull the driveline to ensure it is securely attached to the shaft. Regularly check the driveline yoke to ensure a tight connection. To remove the yoke, remove the connecting cone and pull yoke off the shaft. If the cone cannot be easily removed by hand, drive it out from the other side using a hammer and punch.

NOTE: The clamping cone is serviced only as a complete assembly. Do not attempt to disassemble the clamping cone.

Driveline Yoke

11/16" Bolt End

Clamping Cone

SR20M/SR14M 10/03 Assembly Section 3-12 R 12-06-01

© 2004 Alamo Group Inc.