Alamo SR20, SR14 manual Assembly

ASSEMBLY

ASSEMBLY

FRONT AND REAR DEFLECTORS(Standard Equipment) CHAINGUARDS(OPTIONAL EQUIPMENT at extra cost)(FIGURES 14-17)

DANGER Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and Rear Chain Guards are optional at extra cost. One type of guard must be installed (and maintained in good repair) except for agricultural purposes only in areas where persons, vehicles, livestock, or other property will not be endangered by thrown objects and where such safety equipment would prevent the mower's reasonable performance of its assigned agricultural task.

DEFLECTORS: Front and rear Deflectors (Standard Equipment) are recommended for the average user and will provide superior protection from thrown objects with proper operation under normal conditions. Deflectors must be maintained in good repair or replace after no more than two inches of wear off lower edge.

Attach the Center Front Deflector Brackets (8,9,10) to the Center Section with the bolts 1/2" x 1-1/4” (5), locknuts (4), and flatwashers (2). Fasten the Center Section Front Rubber Deflectors (11) (FIGURE 14) to these brackets with bolts 3/8" x 1” (1) locknuts (4) flatwashers (2), and woodwasher (3).

Attach the Front Wing Deflectors (13) to the wing sections with the bolts 1/2" x 3-1/2”

(6) Whiz Nut Flanged (7), and retaining bars

(12).

Fasten the Rear Rubber Deflectors (6,8) (FIGURE 15 & 16) to the Center Section and Wing Sections with 1/2" x 1-1/4” bolts (1), locknuts (2), and retaining bars (7,9). Note that the Center Rear Deflector is attached to the inside of the Center Section

FIGURE 14. Front Rubber Deflector Attachment.with 1/2" x 1” Bolts (3), Locknuts (2), and Washer (4) see the detail in FIGURE 16.

2,4

3

FIGURE 15. Rear Wing Section Deflector Attachment		FIGURE 16. Rear Center Section
			Deflector attachment
SR20M/SR14M 10/03	Assembly Section 3-10

© 2004 Alamo Group Inc.