Configuring the Switch
2-45
802.1Q VLAN Current Table Information

This screen shows the current port members of each VLAN and whether or not the

port supports VLAN tagging. Ports assigned to a large VLAN group that crosses

several switches should use VLAN tagging. However, if you just want to create a

small port-based VLAN for one or two switches, you can assign ports to the same

untagged VLAN (page 2-48). The current configuration is shown in the following

figure.

Parameter Description
Deleted VLAN Entry Counts The number of times a VLAN entry has been deleted from this table.
VID The ID for the VLAN currently displayed.
Creation Time The value of sysUpTime (System Up Time) when this VLAN was created.
Status Shows how this VLAN was added to the switch:
Dynamic GVRP: Automatically learned via GVRP.
Permanent: Added as a static entry.
Current Egress Ports Shows the ports which have been added to the displayed VLAN group,
where “1” indicates that a port is a member and “0” that it is not.
Current Untagged Ports If a port has been added to the displayed VLAN (see Current Egress
Ports), its entry in this field will be “1” if the port is untagged or “0” if tagged.
[Show] Displays the members for the VLAN indicated by the “Sorted by VID” field.
[More] Displays any subsequent VLANs if configured.
Alcatel OmniStack 8008
< 802.1Q VLAN Current Table Information >
Deleted VLAN Entry Counts : 0
VID Creation Time Status
----------------------------------------------------------------
1 0 (0 day 0 hr 0 min 0 sec) Permanent
Current Egress Ports Current Untagged Ports
11111111 11111111
Sorted by VID : 1
[Show] [More]
<OK>
Use <TAB> or arrow keys to move. <Enter> to select
Port 1 Port 8