Replacing the Status Light Board | 63
Replacing the Status Light Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1Align the slots on the status light board with the alignment posts on the palm rest
assembly and secure the status light board in place.
2Replace the screws that secure the status light board to the palm rest assembly.
3Route the status light board cable through the routing guides on the palm rest
assembly.
4Connect the status light board cable to the connector on the system board.
Postrequsites
1Replace the display assembly. See "Replacing the Display Assembly" on page 60.
2Replace the keyboard. See "Replacing the Keyboard" on page 48.
3Replace the center control cover. See "Replacing the Center Control Cover" on
page 44.
4Replace the compartment door. See "Replacing the Compartment Door" on page 15.
5Replace the battery pack. See "Replacing the Battery Pack" on page 13.
6Follow the instructions in "After Working Inside Your Computer" on page 11.
36