Alliance Laundry Systems 907003062 Electrical Requirements

Electrical Requirements

NOTE: To ensure protection against shock, this

tumble dryer MUST be electrically grounded in

accordance with the local codes or, in the absence of

local codes, with the latest edition of the Nati onal

Electrical Code ANSI/NFPA No. 70. In Canada the

electrical connections are to be made in accordance

with CSA C22.1 latest edition Canadian Electrical

Code, Part I and/or local codes. Electrical work

should be done by a qualified electrician.

IMPORTANT: Electrical connections must be

made by a qualified electrician using data on serial

plate, installation manuals and wiring diagram

provided with machine and according to local

codes. Install a circuit breaker as close to the

tumble dryer as possible. If more than one tumble

dryer is being installed, a circuit breaker must be

provided for each.

NOTE: Connect machine to an individual branch

circuit not shared with lighting or other equipment.

NOTE: 3 Phase Machines Only - Do not use fuses

to avoid the possibility of “single phasing” and

causing premature failure of the motors.

Grounding Instructions

This tumble dryer must be grounded. In the event of

malfunction or breakdown, grounding will reduce the

risk of electric shock by providing a path of least

resistance for electric current. This tumble dryer must

be connected to a grounded metal, permanent wiring

system; or an equipment grounding conductor must be

run with the circuit conductors and connected to the

appropriate ground location.

Metal conduit and/or BX cable is not considered

ground. Connecting the Neutral from the electrical

service box to the tumble dryer ground screw does not

constitute a ground. A dedicated ground conduit (wire)

must be connected between the electrical service box

ground bar and the tumble dryer ground screw.

To reduce the risk of electric shock, fire,

explosion, serious injury or death:

• Disconnect electric power to the tumble

dryer before servicing.

• Close gas shut-off valve to gas tumble

dryer before servicing.

• Close steam valve to steam tumble dryer

before servicing.

• Never start the tumble dryer with any

guards/panels removed.

• Whenever ground wires are removed

during servicing, these ground wires

must be reconnected to ensure that the

tumble dryer is properly grounded.

W002R1

To reduce the risk of fire and electric

shock, check with a qualified serviceman

for proper grounding procedures.

Improper connection of the equipment

grounding conductor may result in a risk

of electric shock.

W068

To reduce the risk of fire and electric

shock, if electrical supply is coming from a

three phase service, DO NOT connect a

“High Leg” or “Stinger Leg” to a single

phase machine. On a three phase machine,

if there is a “High Leg” or “Stinger Leg” it

should be connected to L3.

W069

WARN ING

In case of servicing (or putting the tumble

dryer out of order), disconnect the tumble

dryer from the main supply by switching

off the circuit breaker.

W796