Ā© Copyright, Alliance Laundry Systems LLC ā DO NOT COPY or TRANSMIT
Installation
70420801 (EN)
24
Figure 3
How to Adjust Gas Valve Governor/Regulator1. Check gas burner orifice (manifold) pre ssure as
follows. Refer to Figure 3.
2. Remove screw plug from inside pressure tap.
3. Connect a āUā-tube manometer (or similar
pressure gauge) to the orifice (manifold) pressure
tap.
4. Start tumble dryer and note pressure once flame
is burning. Remove regulator cap and adjust
regulator screw until the burner orifice pressure
per applicable table is achieved. Replace
regulator cap.
5. Commission tumble dryer for use.
Figure 4
TMB1376N1Pressure Tap (Alternate location) 4Pressure Tap
2Manometer 5Gas Valve Flange
3Burner Tube Attaching Screws 6Gas Valve
STATUSDRYINGCOOL DOWNDOOR OPENCUSTOMHIGHMEDIUMMED LOWLOWNO HEATTEMPDISPLAYSIGNALF/ C
TEMP
PROGRAMAUTO
SPECIAL
CYCLE
MORE
CONDITION
SPECIAL
TIME
COOL
DOWN
LESS
SAVE
CUSTOM
TIME
*+--*PROG
AUTO
AUTO
ON / SELECTSTARTSTOP/RESETREVERSINGTMB1376N