Refer to the Water Saving System (WSS) General Specifications in this section to determine if there is adequate clearance through the door for the machine. If there is not and the WSS needs to be removed, refer to the section “Removing the Top Section”. If clearance is sufficient, proceed as follows:

NOTE: Allow concrete to cure before beginning installation.

1. Place the WSS next to the concrete foundation.

IMPORTANT: Move the WSS by lifting from the frame only. Never move by lifting, pulling or pushing the tanks.

2.Remove the carriage bolts holding the wooden skid to the WSS frame side legs.

3.Place the WSS over the mounting bolts.

4.Level the frame top section and sides. Align with the washer-extractor.

NOTE: No part of the washer-extractor and the WSS should be touching. If the machine requires elevating during bolt down then the WSS will require the same amount.

5.Tighten mounting nuts and washers to secure frame to floor.

Installation

Removing Top Section

If removing the top section is necessary due to insufficient clearance, refer to Figure 3 and proceed as follows:

1. Place the WSS next to the concrete foundation.

IMPORTANT: Move WSS by lifting from the frame only. Never move by lifting, pulling or pushing the tanks.

2.Secure top section with lifting equipment.

3.Remove the eight nuts and bolts from the top section that fasten the frame sides to the top section. Refer to Figure 3.

4.Secure both frame sides in place and lift top section with lifting equipment.

5.Remove the frame sides from the wooden skid by removing the carriage bolts holding them to the skid. Remove frame support bar. Refer to Figure 3.

6.Place both frame sides over the mounting bolts and replace frame support bar. Snugly screw down the mounting nuts. Do not tighten nuts at this time.

F232122

11