
Instructions for Installation of Pocket Hardmount Models (UWPV) with Water Saving System
Read the following instructions thoroughly before proceeding. The installer must have a comprehensive understanding of the instructions before attempting installation of the WSS. Refer to Water Saving Tank Frame Foundation section for frame boltdown.
WARNING
Lock out the main power panel and lock out the power supply to the control box before attempting any service procedures.
SW007
IMPORTANT: Ensure that the machine is installed on a level floor of sufficient strength and that the recommended clearances for inspection and maintenance are provided. Never allow the inspection and maintenance space to be blocked.
Refer to the WSS Electrical Specifications for voltage information.
Refer to the WSS General Specifications in this section to determine if there is adequate clearance for the machine. If there is not and the WSS needs to be removed, refer to the previous section “Removing Top Section”.
1. Connecting the WSS to
NOTE: The tank drain hose assembly is packaged inside
a. Remove tank drain hose assembly from packaging. Slide drain hose over tank drain valves and
Installation
Tank Drain Hose Assembly
1 | 2 |
Top View
Front View
3
NOTE: Right and Left are as Viewed from the Rear
Q038I
1To Right Tank Drain Valve
2To Left Tank Drain Valve
3To
Figure 4
For 220V Machines:
a.For electrical
NOTE: Receptacles and plugs are keyed for proper connection. For example, the control signal cable will only fit in “C1”. Do not use excessive force when connecting.
For 110V Machines:
a. Loosen the nut from the back of the PG9 strain relief found on the
b.Connect the
F232122 | 13 |