
Operating Instructions
ON / SELECT |
| STATUS | PROGRAM |
|
HIGH | START | DRYING | AUTO | TIME |
|
|
| ||
|
|
| AUTO |
|
MEDIUM | STOP/RESET | COOL DOWN | SPECIAL | SPECIAL |
CYCLE | TIME | |||
MED LOW | TEMP | DOOR OPEN | *TEMPAUTO | COOL |
| DISPLAY |
|
| *DOWN |
| F/ C |
|
|
|
LOW | SIGNAL | CUSTOM | MORE | LESS |
|
|
| + | |
NO HEAT | REVERSING |
| CONDITION | SAVE |
|
|
| CUSTOM | |
|
|
|
| PROG |
T359I
T359I
Figure 6
Electronic OPL Control
1.To use an Automatic Cycle, press an ON/ SELECT pad. Select HIGH, MEDIUM, MED LOW, LOW or NO HEAT for items that should not be dried with heat. A light to the left of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to section Programming the Electronic OPL Control.
NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 7.
2. Press START pad to start tumbler.
NOTE: All pads can be pressed in any sequence without damaging control or tumbler. To stop the tumbler at any time, open the door or press STOP/ RESET. The window display will flash. Press STOP/RESET twice (within 3 seconds) to end the cycle and reset the control to idle status. To restart the tumbler, CLOSE door and press START pad.
WARNING
To reduce the risk of bodily injury, the tumbler stops tumbling when the door is opened. Do not use the tumbler if it does not stop tumbling when the door is opened or starts tumbling without pressing the START pad. Remove the tumbler from use and call for service.
W078
3.When the cycle is complete, open door and remove the laundry.
T306I
Figure 7
16 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | M414462 |