Alliance Laundry Systems T453I manual 22

Programming the Electronic OPL Control

NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 10.

T306I

Figure 10

Signal

(Refer to Figure 11)

The signal has three loudness levels that can be set anytime the control is activated. Pressing the SIGNAL pad once produces the softest tone. Press the pad again to increase signal volume. The fourth press turns the tone and light off. The loudness level selected is for all cycles until changed.

When the signal is on and any key pad is pressed, it sounds at the selected level to confirm the pad was properly pressed.

Reversing

(Refer to Figure 11)

NOTE: Not all tumblers will have the reversing option.

When this is selected, the cylinder will rotate in one direction for 25 seconds, pause for 6 seconds, then rotate in opposite direction for 25 seconds.

This sequence will repeat until the selected cycle ends. To turn Reversing option off, press the REVERSING pad. (Any time reversing pad is pressed, the cylinder will pause for 6 seconds.)

Status Lights (Refer to Figure 11)

	Lights when door is open.
DOOR OPEN	NOTE: Display window also
	flashes.
DRYING	Lights when laundry is drying.
COOL DOWN	Lights when laundry is cooling.
CUSTOM	Lights when a Custom cycle is
	programmed, recalled or running.
SIGNAL	When lit, the signal will sound when
	the laundry is ready for removal.
	When lit, the cylinder will rotate in
REVERSING	one direction for 25 seconds, pause
	for 6 seconds, then rotate in opposite
	direction for 25 seconds.

STATUS

DRYING

COOL DOWN

DOOR OPEN

SIGNALCUSTOM

REVERSING

T398I

STATUS LIGHTS

T398I

Figure 11

20 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M414462