Programming the Electronic OPL Control

Special Cycle Mode

This allows the user to select the number of times the tumbler will cycle from heat-on to heat-off. To enter the Special Cycle Mode, press the SPECIAL CYCLE pad after selecting a cycle. The display will read “SC:**”. “**” is the number of times the tumbler will cycle from heat-on to heat-off. This number can be changed by pressing the MORE or LESS pads. For increments of 1, press pad and release. For increments of 5, press pad and hold for 3 seconds. Range is from 1 – 99.

Press the START pad and the number shown after “SC:” is the number of cycles selected, the number will decrease as each cycle is completed. The default cool down cycle for the Special Cycle Mode is Automatic Cool Down.

NOTE: Since there is only 60 minutes of cycle time, any cycles not completed within 60 minutes will be skipped.

NOTE: Unlike the Time Dry mode and Automatic mode, the regulating temperature in the Special Cycle Mode has a range of 80°F (27°C) to 180°F (82°C) or all heat cycles.

Special Time Mode

This mode is just like the Time Dry mode, except that the regulating temperature for each heat cycle ranges from 80°F (27°C) to 180°F (82°C). To enter the Special Time mode, press the SPECIAL TIME pad after selecting a cycle. The display will read “St:**”, where “**” is the drying time. This time can be changed by pressing the MORE or LESS pads. For 1 minute changes, press the pad and release. For 5 minute changes, press the pad and hold. Maximum drying time allowed is 60 minutes.

AC:**” will be displayed when tumbler is in Auto Cool Down. Typical cool down times for fabric selections are preset. The cool down time can only be altered before cycle is started. To alter cool down time press the COOL DOWN pad and then press the MORE or LESS pad (when cool down time is altered, “TC:**” will be displayed). For 1 minute changes, press pad and release. For 5 minute changes, press pad and hold. Cooling time can be from 1 to 39 minutes. To return to the Auto Cool Down, press MORE or LESS pad until “AC:**” is displayed.

To start the cycle, press START. The total drying time plus cool down time will display. During the cycle, remaining time displays.

Security Lock-Out

The programming pads can be “locked-out” so operators cannot change cycles on their own. When lock-out is used, the operator can use only the factory- set Automatic cycles and the one Custom cycle allowed per Select pad. Before using lock-out, create all desired Custom cycles.

To lock-out, hold SIGNAL pad and press MORE in the idle mode.

To unlock, hold SIGNAL pad and press LESS in the idle mode.

Show Mode

This mode will show all LED’s and light up entire display while deactivating all pads. This mode allows loading door to be opened and closed. To enter this mode, the control must first be in the idle mode. Hold the START pad and press the SAVE CUSTOM pad. To exit Show Mode, hold the START pad and press the SAVE CUSTOM pad.

24

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

M414462