Allied Telesis AT-X510-28GSX, AT-X510-52GTX manual Problem 6 The switch functions intermittently

Models: AT-X510-28GPX AT-X510-28GSX AT-X510-52GPX AT-X510-28GTX AT-X510-52GTX

1 90
Download 90 pages 11.79 Kb
Page 83
Image 83

x510 Series Installation Guide for Stand-alone Switches

Test the attenuation of both directions on the fiber optic cable with a fiber optic tester to determine whether the optical signal is too weak (sensitivity) or too strong (maximum input power).

Problem 5: Network performance between a twisted pair port on the switch and a network device is slow.

Solution: There might be a duplex mode mismatch between the port and the network device. This can occur when a twisted pair port using Auto- Negotiation is connected to a remote device that has a fixed speed of 10 or 100 Mbps and a fixed duplex mode of full duplex. If this is the cause of the problem, adjust the duplex mode of the port on the network device or switch so that both ports are using the same duplex mode. You can use either the LEDs or management software on the switch to determine the duplex mode settings of the ports. The LEDs are described in Table 6 on page 34.

Problem 6: The switch functions intermittently.

Solutions: Check the system hardware status through the management software:

Use the SHOW SYSTEM ENVIRONMENT command in the Privileged Exec mode to verify that the input voltage from the power source to the switch is stable and within the approved operating range. The unit will shutdown if the input voltage fluctuates above or below the approved operating range.

Use the SHOW SYSTEM ENVIRONMENT command in the Privileged Exec mode to verify that the fan is operating correctly.

Verify that the location of the switch allows for adequate airflow. The unit will shutdown if it is in danger of overheating.

Problem 7: The Switch ID LED on the front of the switch is flashing the letter “F.”

Solutions: One or more of the following problems has occurred:

A cooling fan has failed.

One of the power supplies has failed.

The input voltage on one or both of the power supplies is outside the normal operating range.

The internal temperature of the switch has exceeded the normal operating range and the switch may shut down.

Contact your Allied Telesis sales representative for assistance.

83

Page 83
Image 83
Allied Telesis AT-X510-28GSX, AT-X510-52GTX, AT-X510-28GTX, AT-X510-52GPX manual Problem 6 The switch functions intermittently