Allied Telesis AT-X510-52GTX, AT-X510-28GTX manual Installing the Switch in an Equipment Rack

x510 Series Installation Guide for Stand-alone Switches

Installing the Switch in an Equipment Rack

This procedure requires the following items:

Eight bracket screws (included with the switch)

Two equipment rack brackets (included with the switch)

Flat-head screwdriver (not provided)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)

Installation guidelines may be found in “Choosing a Site for the Switch” on page 50. Here is the procedure for installing the switch in a 19-inch equipment rack.

Caution

The chassis may be heavy and awkward to lift. Allied Telesis recommends that you get assistance when mounting the chassis in an equipment rack.  E28

1. Place the unit upside down on a level, secure surface.

Figure 14. Turning the Switch Upside Down

2.Using a flat-head screwdriver, pry the rubber feet from the bottom of the switch. Refer to Figure 15.

Figure 15. Removing the Rubber Feet

55