Allied Telesis CG-WLBARGS manual Windows Me/ 98, Use hardware, Use software

WLBARGS Manual

<Windows Me/ 98/ 95>

(1)Click [Start] => Click [Run].

(2)Input [winipcfg] in the column => press [Enter].

(3)Select your network adapter to display IP address. The IP should be 192.168.1. x ,if none, please click [Release] => Click [Renew].

Q7. How to reboot the product?

A:Reboot to get new setting values applied. The steps are as follows: open the management program-> Click on [Management]-> Click on [Proceed] in the [Reboot] column.

*Note: The definitions of [Reboot], [Firmware update], and [Reset to default settings] are different. Please make sure of your intention before proceeding.

Q8: How to reset to default settings?

A:If you forget the password, get failed in setting or product hang up; you can reset the product’s settings to default values. There are 2 ways for setting:

* Use hardware

(1)Use a spindle item (e.g. a clip) to press [Init button] in the back side of the product until [Status] lights up with red.

(2)After the red light goes out, the system will restore its default values.

* Use software

(1)Click on the [Management] function item -> click on[Back to default setting] item from the setting page ->Click on [Proceed] to reset to default setings.

49