Alpine CDA-7990 manual Multi-ChangerSelection, 43-EN, When a 12-discCD Changer is connected

When a 12-disc CD Changer is connected:

To select discs numbered from 1 to 6, the proce- dure is the same as for the 6-disc CD Changer. To select discs numbered from 7 to 12, first press the FUNC button. This changes the “D” indicator to “d”. Then press the desired Disc Select button. With the FUNC button activated, the Disc Select buttons 1 to 6 will represent discs 7 to 12 respec- tively.

Multi-Changer Selection

Alpine’s Ai-NET system will support up to 6 CD Changers. When operating two or more changers, the KCA-400C (Multi-Changer Switching device) must be used. If you use 1 Switching device, you can connect up to 4 CD Changers. If you use 2 Switching devices, you can connect up to 6 CD Changers.

1 Press the SOURCE button on the CDA-7990 to activate the CD Changer mode.

Alternatively, press the SOURCE button on the optional Remote Control to activate the CD Changer mode. Proceed to Step 3 below to select the desired CD Changer.

2 Press the BAND button on the CDA-7990 or the optional Remote Control to activate the CD Changer Selection mode.

3 The CD Changer Selection mode remains active for 3 seconds after Step 2 is performed. Press the BAND button until the desired CD Changer indicator appears on the display.

Alternatively press the BAND button on the optional Remote Control until the desired changer indicator appears on the display.

4 To operate the selected changer, see “CD Operation” section.

•Press the FUNC button to turn the function indicator off, then, select the discs numbered from 7 to 12.

•If the selected CD Changer is not connected, the display will show “NO CHANGER”.

43-EN