Getting Started
Joystick
Flipper switch
Operation is carried out by the commander. If an Alpine touch panel monitor is connected to this unit, the touch buttons appear in the display to enable touch operation.
This manual explains operation using the commander. For details of the touch operation, refer to “Soft button operation” on page 39.
•The commander vibrates when an operation is performed. Refer to “Turning the Commander Vibration ON or OFF” (page 13).
Feature
If an Alpine
Accessory List |
|
Main unit | 1 |
Power cable | 1 |
Parking brake | 1 |
Factory System Cable | 1 |
Pinch connector | 6 |
Bracket | 2 |
Tapping screw (M4 × 14) | 4 |
Pan screw (M4 × 8) | 4 |
Velcro fastener | 2 |
RGB cable (3M) | 1 |
RCA extension cable (3M) | 1 |
Antenna extension cable (3M) | 1 |
Commander | 1 |
Holder | 1 |
Commander connection cable (3M) | 1 |
1 | |
Reinforcement screw | 3 |
Cable clamp | 3 |
Initial System Start-Up
Be sure to press the RESET button when using the unit for the first time, after installing the CD changer, after changing the car battery, etc.
1 Turn off the unit power.
2 Press RESET with a
RESET
Turning Power On or Off
Some of this unit’s functions cannot be performed while the vehicle is in motion. Be sure to stop your vehicle in a safe location and apply the parking brake, before attempting these operations.
1 Press SOURCE/POWER to turn on the unit.
•The unit can be turned on by pressing any button.
2 Press and hold SOURCE/POWER for at least 2 seconds to turn off the unit.
Displaying the Unit Source on the Monitor
By selecting the image source on the unit, it can be displayed on a connected monitor. For operation, refer to the Owner’s Manual of the monitor.
If an Alpine monitor is connected (RGB connection)
1Recall the navigation mode by selecting the image source on the monitor.
The source of the unit is displayed.
