OPERATING INSTRUCTIONS
OPERATING FEATURES & FUNCTIONS
To stop an operation at any time — Press and hold the Start Key until the control beeps for two seconds, indicating the operation has been cancelled. The oven will remain in a
To turn oven control panel off — Press and hold the
On/Off Key until the oven beeps. The On/Off indicator light will go out.
Door open indicator — Display will flash “door” and a triple beep will alert the user. Press On/Off key to acknowledge error and disable triple beep.
Arrow Keys:
Cook, Hold and Probe Temperature, and the Time setting can be adjusted by pressing the Arrow keys. Pressing and releasing the Arrow key will change settings in increments of one. To change a setting more rapidly, press and hold the Arrow key. Once the setting reaches a number divisible by 10, it will begin to increase in increments of 10.
Green and Amber Indicators: | Green |
Each program key includes a green |
|
light which indicates a requirement | Amber |
for additional programming by the | |
operator or the current operational |
|
state of the oven. |
|
The Cook, Time, Probe, and Hold keys include an amber indicator light to identify the information being displayed.
Power Fail Detect:
If the power were to fail for any reason while heating, the control will retain, in memory, the programmed operating conditions. When power is restored, the control will resume operating from the point where it was interrupted and the On/Off indicator light will flash, indicating that such an event did occur. The operator can acknowledge the power failure by pressing the On/Off key. Pressing the key will display the amount of time that the power has been off. The control will stop counting the amount of time the power has been off when it has been off for more than 24 hours.
NOTE: If such an event has occurred, it is strongly recommended that you ensure the food is safe for consumption according to local health regulations.
Display High/Low Probe Temperatures:
To observe the recorded maximum or minimum probe temperature when cooking by probe, press the following keys while the probe remains in the product:
Highest Temperature: Press Probe Key and Up Arrow Key at same time.
Lowest Temperature: Press Probe Key and Down Arrow Key at same time.
Probe Usage:
When the oven probe remains inserted in the probe bracket, the LED temperature display will indicate the ambient air temperature inside the oven. To use the probe for cooking remove it from the bracket and wipe the full length of the metal probe with a disposable alcohol pad to clean and sanitize before using.
Only the tip of the probe senses the internal product temperature; therefore, it is important the tip be placed correctly in the product for internal temperature accuracy. Push the probe tip halfway into the product, positioning the tip at the center of the food mass. When inserting the probe into solid foods such as meat roast or poultry breasts, push the probe in from a straight downward position or in from the side to the center position. If placing into a
NOTE: When cooking by probe, insert the probe into the raw product after the oven has been preheated.
WAIT ONE FULL MINUTE to allow the probe temperature to decrease to the internal temperature of the product. Press the start button to begin the cooking process after this probe temperature adjustment period. A false probe reading of the internal product temperature will cause the oven to default to a holding temperature.
Probe Calibration:
1.To verify product probe calibration, place the probe in a warm glass of water along with a quality independent digital thermometer and press the probe key for five (5) seconds. Compare readings.
2.If calibration is required, the unit must be in the power up hold mode. From the off state turn the unit on. The unit will begin to operate in the power up hold mode, press the probe key for eight (8) seconds until the unit beeps twice and a temperature is displayed. Adjust the probe temperature to match the independent probe by pressing the up or down arrows to increase or decrease the temperature. Repeat step 1 to verify.
3.Repeat steps 1 and 2 to verify the probe calibration as necessary.
pg. 16 | TH/III installation/operation/service manual |
