c l e a n i n g & maintenance
cleaning schedule
DAILY GASKET CLEANING
It is important to prolong the life of the oven gasket by cleaning on a daily basis. Routine cleaning will help protect the gasket from deterioration caused by acidic foods.
1.Allow the oven to cool, then wipe the gasket and crevices with clean cloth soaked in warm detergent solution.
2.Wipe the gasket and crevices with a cloth and clean rinse water.
Do not attempt to remove gasket or place in the dishwasher.
PROBE USAGE AND CLEANING
After each use of the CORE TEMP mode, wipe the probe tip with a clean paper towel to remove food debris. Follow by wiping the probe with a disposable alcohol pad. Return the probe to the proper door bracket position.
Probe Cleaning Procedures
1.Remove all food debris from probe between loads and at the end of each production shift. Wipe the entire probe, probe cable assembly, and probe holding bracket with a clean cloth and warm detergent solution.
2.Remove detergent by wiping the probe, cable, and bracket with a cloth and clean rinse water.
3.Wipe probe and probe bracket with disposable alcohol pad or sanitizing solution recommended for food contact surfaces.
4.Allow probe and cable to air dry in the probe holding bracket.
5.Wipe the probe with a disposable alcohol pad prior to inserting into a new food product.
DAILY OVEN CLEANING
To be performed at the end of the production day or between production shifts.
DAILY STEAM GENERATOR FLUSH
(Electric boiler equipped models only) See next page for instructions
The steam generator must be flushed once a day when operating the oven on a regular basis. This procedure will prevent lime deposits and scale
daily prong cleaning To ensure accurate internal product temperature readings, the prongs on the removable probe must be cleaned daily.
1.Remove all food debris from prongs at the end of each production shift. Wipe the
entire prong casing, and between each prong with a clean cloth and warm detergent solution.
2.Remove detergent by wiping with a cloth and clean rinse water.
3.Allow to air dry before replacing detachable probe.
regular DECALCIFICATION
(Electric boiler equipped models only)
Qualified service technician should see CombiTouch Technical Manual for instructions
It is important to decalcify the steam generator, particularly in areas with extremely hard water. In addition to the daily steam generator flush, this procedure should be performed once a month by a qualified service technician or more frequently depending on usage and water conditions.
MONTHLY CLEANING
1. Spray Head
2. Water Intake Filter | 1 |
3. Drain Pipe
2
3 
39
