Removal and Reinstallation of Range
Correct
1.Unplug range cord.
2.Turn off gas valve and disconnect gas supply.
3.Remove range and place aside.
4.Remove
5.To reinstall range, follow instructions in Installation section of this manual.
•Do not reuse a flexible connector after moving appliance.
Place Grates and Burner Caps
Place burner cap on burner base and grate on rangetop.
A
B 
C
Place Grates and Burner Caps
Pegs in the burner base fit into recess in underside of burner cap. To make sure cap is properly aligned and leveled, move burner cap around on burner base. Burner cap must be correctly seated on burner base for proper operation of burner.
Make sure proper cap size is on each burner base. Burner does not burn properly if wrong size burner cap is placed on burner base.
Turn on burners to check for proper operation. See Operating Surface Burners section for burner operating instructions.
Not centered Too small | Too large |
Burner Caps
Test and Adjust Surface Burner Flame
!WARNING
To avoid electric shock that can cause personal injury or death, disconnect main electrical supply to range before servicing.
Turn on burner. See Operating Surface Burners section for burner operating instructions. Surface burner should ignite within 4 seconds. Properly adjusted surface burner flames are clean and blue with a distinct inner cone approximately ¼ inch to ½ inch long. Some yellow flame is normal when burning LP/Propane.
See Adjusting Air Shutter section,
•If burner flame is blowing or noisy, reduce airflow to burner.
•If burner flame does not hold its shape, increase airflow to burner.
A
Burner
Surface Burner Flame
13
