BASIC OPERATIONS (CONT.)
16. PROGRAM PLAY
This operation allows you to customize your disc playback. You may select specific tracks to played and the order they will be played in. You may program a maximum of 20 tracks at once and program a single track to played more than once. To create a program:
1) Be sure a disc is inserted in the drive and press the PRG/HOLD FX (13). Pressing the PRG/HOLD FX (13) from any function will immediately pause the disc and enter the program mode.
2)After activating the program mode the program indicator LED beside the PRG/HOLD FX (13) and the PROGRAM INDICATOR
(52) in the LCD (14) will begin to glow indicating Program Mode has been activated.
Figure 27
3) Select a track to be programmed by using the FORWARD TRACK SKIP (21) and BACK SKIP TRACK BUTTON (20).
Figure 28
4) Once you reach the track you wish to place in to the program memory pressing PRG/HOLD FX (13) will lock the track into memory.
Figure 29
5)Repeat these steps three and four up to 29 times (up to 30 tracks may be programmed).
6)As you program tracks in memory the LCD (14) will indicate the tracks that have been programmed in to memory.
7) When you have finished your programming and are ready to begin playback simply press the PLAY/PAUSE BUTTON (29) and your program will begin to play.
8) After you have complete your program you can always add more tracks to your program by repeating the steps one through four. Remember that you can only a maximum of 30 track in a program and you can only add track not subtract.
9) To cancel and clear the program press and hold down the PRG/ HOLD FX (13) for more than two seconds (see figure 29).
Figure 30
American Audio® •
