AMX NXR-ZGW/-ZRP manual Using the ID Button to Change the NXR-ZGW’s Device Number

Device Configuration

Using the ID Button to Change the NXR-ZGW’s Device Number

1.Launch NetLinx Studio 2.4 (default location is Start >Programs > AMX Control Disc > NetLinx Studio > NetLinx Studio 2.4).

2.Access the Device Addressing dialog (FIG. 18) by selecting Diagnostics > Device Addressing from the Main menu.

Enter the new NXR-ZGW value

Assign the new value to the NXR-ZGW

AB

FIG. 18 Device Addressing dialog (using the ID mode to set the NXR-ZGW device value)

3.Locate the Device field (A in FIG. 18) and enter the new value for the NXR-ZGW. This value must fall within a range of 0 - 32767.

4.Press the on-screen Start Identify Mode button.

This action causes a previously red *Not Active* field to now display a green Waiting...Press Cancel to Quit.field.

This green field indicates that Studio is waiting to detect the device value of the NXR-ZGW associated with the ID button on the target NXR-ZGW.

5.Press the target NXR-ZGW’s ID button to begin process of reading the current device value of the NXR-ZGW and then assigning it to the new value entered in step 2.

Once the swap has been successfully made, a red Successful Identification Made field appears.

The previous Device value and associated System number of the targeted NXR-ZGW are then displayed below the red field. As an example, Previous D:S=32002:1, where 32002 was the previous device value of the NXR-ZGW (D) and 1 was the System value (S).

34 NXR-ZGW/-ZRP