AMX NXR-ZGW/-ZRP Connections, Finding a device’s EUI address, Finding the device’s description

NXR-ZGW Browser-based Configuration Manager Pages

Connections

All devices connected to the NXR-ZGW is displayed on this page.

FIG. 11 Connections Page

Each device provides the following:

Connections Page

No.	The Netlinx ID number.
EUI-64	The 64 bit ZigBee EUI address of the device.
Description	The device's description, supplied by the device.
Type	The specific type of device being accessed.
Latency	A measure of the amount of time (in milliseconds) for a message round-trip from the device to
	the gateway and back.
LQI	LQ is the link quality of the RF path between the PAN coordinator and the device. Quality
	levels are:
	• not recommended
	• edge
	• marginal
	• good
Status	The current status of the device: either "Active" or "Asleep".

Finding a device’s EUI address

1.In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select Connections under the section Pan.

2.The EUI address is located in the Connections table under "EUI-64". Click on the EUI address to open the PAN Device Details page for this device. (See FIG. 12)

Finding the device’s description

1.In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select Connections under the section Pan.

2.The device’s description is located in the table under "Description".

Determining the device type

1.In the menu on the top of the NXR-ZGW Browser-based Configuration Manager, select Connections under the section Pan.

2.The device type is located in the table under "Type".

NXR-ZGW/-ZRP 21