APWeb – Controlling the Octaire
Navigating the XBar Controller
Output channels
VM title block (levels)
Input channels
Crossbar field with blue & red crosspoints
Cursor shows crosspoint
I/O pair numbers
The crosspoint images in the XBar’s crossbar field represent the intersections of the input channels and the output channels.
VM title block – click to open the VM Selection Pad to change the routing level or update system status
Input channels (on left) – indicate the numbers of the source channels Output channels (on top) – indicate the numbers of the destination channels
Blue crosspoint – blue indicates that there is no active signal; click to route the signal (the crosspoint will remain blue if the switch is not completed)
Red crosspoint – red indicates an actively routed signal; click to disconnect Cursor over crosspoint – move over I/O pairs to display channel numbers
Executing & Disconnecting Switches on the XBar
Use the following directions to control the Octaire from the APWeb site.
To execute or disconnect switches with the XBar:
1.From any page in the site, click the Controller link. The XBar launches.
2.Optional (to change routing level) – Click the VM title block in the upper left corner. The VM Selection Pad dialog box opens.
3.From the VM list, select the new routing level.
4.Close the VM Selection Pad.
Select VM (routing level) from list
Octaire Instruction Manual | 89 |
|
|