Installation & Setup
Rack Installation & System Setup
Octaire Distribution Matrix enclosures fit in a standard EIA 19 in. (48.26 cm) rack (rack ears are provided).
Important: The system requires at least one empty rack unit above and below the enclosure to allow adequate airflow; three empty rack units are recommended.
Required items for rack installation:
Enclosure(s)
Rack ears
Standard EIA 19 in. (48.26 cm) rack
Screwdriver
Screws that fit your rack for mounting the enclosure(s)
Power cords (2 per enclosure)
Link cables (provided with
Optional items for rack installation
PC or laptop computer with a null modem cable (for communication with the Octaire via the
Installation Recommendations
Write the serial number for each enclosure (located on the rear next to the power receptacles) in an easily accessible location before installing the Octaire in a rack.
Use
Attach all power cords (see FIG. 19 on page 27) to surge protector(s) and/or AC line conditioner(s).
Apply power to the Octaire enclosure(s) before applying power to its source and destination devices.
Installation Procedure
A flow chart showing the installation sequence is in FIG. 7. The procedure, which follows on page 18, provides general steps with references to detailed information found in later sections of the manual.
FIG. 7 Installation procedure
Caution: To prevent overheating and airflow restriction, avoid placing high
Octaire Instruction Manual | 17 |
|
|