AVE MV DR4000 manual Mobile Rack HDD Installation

6.

6. Secure the driver in the rack using two mounting screws in both the side-mounting holes. Please don’t tighten the screws too much, otherwise that may damage the driver.

7.	8.	7.	Screw the rack into the device,
			screwing in all the four screws.
		8.	Attach the interface connector and the
			power connector to the drive. Please

note the red lining of the IDE cable and the red wire of power cable must line up side by side.

10.

Place the mobile rack back onto the device and screw it in.

7.2Mobile Rack HDD Installation

1.Make sure that the key unlocked.

2.Pull the active-handle outward to remove the carrier body away from the mobile rack

50