7. IDE Hard Disk Installation

Usually, the unit comes with one hard-disk drive installed in compartment HD 1, which is default-configured as a master. The jumper settings configuration of the installed hard-disk drives for the unit and compatible drives which can be used with this unit are listed in the table below. To install two hard disk drives in compartment HD 1 and HD 2, please take the following steps.

The jumper settings of hard-disk drives for the system

 

Location

Jumper

IDE 1

Compartment HD 1

Master

IDE 2

Compartment HD 2

Master

 

 

 

7.1 Built-in hard disk

1.

1. Unscrew all the mounting screws on the mobile rack of the unit and detach it.

2.3.

2. Carefully lift the mobile rack to a vertical position.

3. Unscrew the secured screws to detach the hard disk rack.

4.

5.

4.

Setting the jumper of your hard disk

 

 

 

 

 

driver. The way to set the jumper of the

 

 

 

drive varies between manufacturers;

 

 

 

please refer to the instructions on the

 

 

 

driver to set the jumpers in the master

 

 

 

position.

 

 

5.

Place the hard disk in the rack.

 

 

 

 

49

Page 51
Image 51
AVE MV DR4000 manual Built-in hard disk, Jumper settings of hard-disk drives for the system Location