Analog Devices 82-0000603-01 Stereo LINEIN DEFAULT, 3 Audio Input Jumper Settings JP1, BMODE0

Stereo LINE_IN (DEFAULT)

MIC	JP1LINE
2	6
1	5

Mono MIC1

MIC	JP1LINE
2	6
1	5

Figure 4-3: Audio Input Jumper Settings (JP1)

4.3.2Audio Codec Disable Jumper (JP2)

Placing a jumper between pins 1 and 2 of JP2 holds the AD1885 in reset, preventing it from driving signals to the serial port. When a jumper is between pins 2 and 3 of JP2, the AD1885 is held in reset until PF15 is set to an output and is asserted. These position are labeled on the board as “DIS” and “ENA 1885”.

4.3.3Boot Mode Select Switch (SW1)

The boot mode select switch determines how the DSP will boot. Table 4-2shows the switch settings for the boot modes.

NOTE: SPI ROM is not available on the EZ-KIT Lite.

Table 4-2: Boot Mode Select Switch (SW1) Settings

BMODE0	BMODE1
Pin 1	Pin 2

BMODE2 Function Pin 3

On	On	On
Off	On	On
On	Off	On
Off	Off	On
-	-	Off

Execute from 16 bit external memory (no boot)

Boot from 8-bit EPROM (Default)

Boot from SPI0 ROM (8-bit addresses)

Boot from SPI0 ROM (16-bit addresses)

All others reserved

4.3.4DSP PLL Setup Switch (SW2)

The DSP’s Phase Lock Loop (PLL) multiplies the 20 MHz input clock by a multiplication factor to set the core clock speed of the DSP. Internal to the DSP the Programmable Flags, PF0-PF9, are multiplexed with the PLL setup signals, SSEL0-6, DF, and MSEL0-1.

ADSP-21535 EZ-KIT Lite Evaluation System Manual 4-6