Using EZ-KIT Lite
Figure 1-1. EZ-KIT Lite Hardware Setup
To start up an EZ-KIT Lite session in VisualDSP++:
1.Verify that the yellow USB monitor LED (LED11, located near the USB connector) is lit. This signifies that the board is communicat- ing properly with the host PC and is ready to run VisualDSP++.
2.From the Start menu, navigate to the VisualDSP++ environment via the Programs menu.
If you are running VisualDSP++ for the first time, the New Session
ADSP-21369 EZ-KIT Lite Evaluation System Manual | 1-5 |
