Control panel (cont.)
Keys 10 and 11 | key 18 |
These keys are used to select commands in the main menu and access the secondary messages.
Key 12
This key is used to validate the user’s choice.
Key 13
This key is used to access the main menu: display language, display- contrast setting, sound level of the buzzer, lamp test, date and time settings,
"V" key 14
This key is used to access voltage measurements:
◗normal AC source
◗bypass AC source
◗load
"A" key 15
This key is used to access current measurements:
◗normal AC source, bypass AC source and load currents;
◗percent load;
◗load crest factor.
This key is used to access the primary messages.
"Battery" key 19
This key is used to access battery measurements:
◗battery voltage (or the DC voltage on frequency converters without a battery);
◗battery current (charge or discharge);
◗battery temperature;
◗available battery backup time;
◗inverter load level (percent).
"Forced-transfer" key 20
This key is used to voluntarily transfer the load to the inverter or from the inverter to the static bypass (return transfer). Transfer and return transfer are carried out only following confirmation requested by the system display and a warning as to the risk of an interruption in the supply of power to the load.
"Alarm reset" key 21
This key is used to reset stored alarms. The system accepts resetting only when alarms have been cleared.
"Buzzer reset" key 22
This key is used to stop the buzzer. However, new alarms set the buzzer off again.
"W.Hz" key 16
This key is used to access other measurements:
◗normal AC source, bypass AC source and inverter frequencies;
◗level of active and apparent power drawn by the load;
◗load power factor;
◗inverter load level (percent).
Display 23
The display continuously indicates the system operating status.
"Anomaly" indicator light 17
This indicator light indicates the presence of anomalies.
