Stabilizing the Equipment
Floor brackets
To prevent the equipment from moving from its final location (if it is not joined with an enclosure), use the included
Joining to enclosures
NetShelter™ SX enclosure. Two joining brackets are installed on the front and rear of the equipment. Depending on how the holes on the joining brackets are used, you have the option of either
1.Remove the front and two rear doors from the equipment. See “Door removal” on page 13.
2.Locate the four joining brackets on the equipment. Rotate each bracket 90° toward the adjoining enclosure so that the bracket is parallel to the floor.
na1573a |
3.Install the brackets using the Phillips screws provided with the equipment.
NetShelter VX enclosure. The equipment may be joined to a NetShelter VX enclosure
InRow RC Installation | 15 |
