
There are several ways to control the Sonic Blasters output volume. The different methods are explained more in the following section, “A Note About Volume Control.’ Right now, however, you’ll need to Set the volume on the card itself:
◊If you have an amplifier connected or if you’re using amplified speakers, turn the volume on the card up a very little bit. The arrows will be pointed almost straight left. (See illustration following.)
◊If you don’t have an amplifier or amplified speakers connected, set the card’s volume to about
Volume Pots |
| Volume Pots |
set to low | Cables to Connector | set to medium Cables to Connector |
| Plate | Plate |
Volume setting | Volume setting |
w/ amplifier connected | w/o amplifier connected |
11)Replace the Apple’s cover.
12)Now, use the Control Panel to set the slot setting for the Sonic Blasters slot to, “Your Card.”
If you plan to use the Sonic Blaster for playback only, you can skip this step. (Refer to the section “Where It Goes” on page 1 for details.)
If you don’t know how to change the settings in the Control Panel, refer to your Apple IIGS Owner’s Guide for instructions on setting the slot using the Control Panel.
I n s t a l l a t i o n i s c o m p l e t e !
Ch. 2 - Putting it in | 9 |