4. If Message 1 does not
appear after 30 seconds,
press the remote control’s
SATbutton. Then press
the remote’s PWR button.
The receiver beeps twice,
the Antenna status light begins to flash green,
and the Voltage status light should be lit green.
If the receiver’s Voltage status
light is off, press the power
switch on the front of the
receiver to turn on the
receiver.
54-0376 2.3
Getting Started
2-1 Turning On the Antenna
To quickly start watching satellite TV using the
TracVision system, follow the simple steps below.
1. Apply power to the mobile receiver/controller.
The Receiver status light should turn green.
2. Turn on your TV and select the satellite input (not
the VCR input).
3. Wait 30-60 seconds for the antenna to acquire the
satellite signal. The TV will show the following:
Installation
If your satellite dish is ready for DIRECTV
®
service, please wait until your
Advanced Program Guide
™
is prepared.
Signal not available...
Installation
If your satellite dish is ready for DIRECTV
®
service, please wait until your
Advanced Program Guide
™
is prepared.
Acquiring guide data...
Message 2
Message 1
PWR
DVD VCR AUX TV SAT
GUIDE
MENU TURBO FAV
N
E
L
I
N
E
G
U
I
D
Status Lights
Power Switch
For details about the status
lights, see Section 10-4,
“System Status Lights”on
page 10.10.