10-5 Viewing Diagnostic Information
Follow the steps below to view diagnostics
information on the receiver.
1. Using your primary receiver, press the MENU
button to access the main menu.
2. Highlight the System Setup tab and press
SELECT.
3. Highlight the Antenna tab.
4. Highlight the Diagnostics button and press
SELECT.
Component Possible States
Receiver State OK / Error
Antenna State Idle / Initializing / Searching / Tracking /
Error
Current Sat Name of satellite the antenna is tracking
RF OK / Low / Error; Actual RF level
Available Sats List of installed satellites / Error
Component Possible States
GPS Position Current position in latitude/longitude /
Acquiring / Error
Cable OK / Shorted / Open
System DC OK / Low / Bad;Actual VDC at receiver
Antenna DC OK / Error ;Actual VDC at antenna
Gyro OK / Error
10.12
DIRECTV Mobile Receiver/Controller User’s Guide
Antenna
Antenna Controls
Current Settings
Diagnostics
Modify Settings
Sat Select
Receiver State: OK
Antenna State: Tracking
Current Sat: 101
RF: OK; 95
Available Sats: 101, 119
GPS Position: 42.1N 72.3W
Cable: OK
System DC: OK; 11.5
Antenna DC: OK; 30.2
Gyro: OK
If errors, call KVH: 401-847-3327
Antenna
Diagnostics
If the receiver reports an error, please contact
Technical Support for assistance. See Section 10-8,
“Technical Support” on page 10.15.
54-0376