Ground Loop Generating Electrical Noise
The system’s audio cables might pick up the electrical
noise or hum caused by a ground loop on the
vehicle/vessel. To eliminate this noise, install a
ground loop isolator in-line between the receiver’s
“Audio” jacks and your TV’s audio input. (use Radio
Shack model 270-054 or equivalent)
Audio/Video System Faulty
If there is no picture on your TV, your mobile
audio/video system may be faulty. Please seek
technical assistance from either the installer of your
audio/video system or a dealer authorized by the
system’s manufacturer to repair the system.
Antenna or Receiver Faulty
In the case of a faulty antenna or receiver, please seek
technical support as described in Section 10-8,
“Technical Support” on page 10.15.
Do NOT attempt repairs yourself.Refer all
servicing needs to qualified service
personnel. Evidence of tampering or
unauthorized repairs will void the warranty.
54-0376 10.9
Troubleshooting
RF Converter Too Close to Receiver
The RF converter must be placed at least three feet
away from the receiver. Placing the RF converter
closer to the receiver may result in interference,
causing the remote control to operate intermittently
or not at all. Also make sure the RF converter is not
located behind a metal structure.
Remote Control Batteries Dead
Replace the two AAAbatteries as shown below,
observing the correct polarity.
Remote Control Batteries
If you lose your remote control, please call
or visit your local KVH authorized dealer to
order a replacement.