5840_CIB_2ATT 2002.11.7 5:47 PM Page 5
figure a
figure b
figure c
Wall Installation
1Connect the power cord and telephone line cord to the underside of the corded base, as shown (figure a).
2Position the mounting bracket as shown (figure b).
3Feed the telephone line cord through the hole in the center of the mounting bracket (figure b), align the bracket with the base, and slide it into the hole on the base as shown (figure c).
4Lock the mounting bracket in place (figure d).
5Plug the telephone line cord into a modular wall jack, and mount the base on the wall (figure e).
a)Align holes on base with mounting studs on wall jack.
b)Place power cord as shown.
c)Pull base down on mounting studs until it locks into place.
6Plug the power cord into an electrical outlet not controlled by a wall switch (figure e).
Use only the power cord supplied with this product. If you need a replacement, call 1 800
7Follow Steps 3–5 in “Table/Desktop Installation.”
INSTALLATION |
figure d
figure e
5
