AT&T 8410 manual Speaker

To cancel Send All Calls 1 If you are using an 8410 with a display, press [ Menu ]

and then press the softkey below SAC again (while on-hook)

If your 8410 does not have a display or if SAC is not available on your display, press [ Send Calls ] again (while on-hook)

or Dial Send All Calls cancel code
(while on-hook)	[confirmation tone]

Speaker

Note: Your voice terminal is set for either the Speaker (listen-only) or the Speakerphone (listen and talk) function. Check with your system manager to see which of these two features you can use.

You can use the Reset Speakerphone feature only if your voice terminal is set for Speakerphone (listen and talk).

Use the following procedures if your voice terminal is set for the Speaker (listen-only) feature.

To place a call without lifting the handset, or to use speaker with any listening-only feature activity (such as, monitoring a call on which you have been put on hold or for group listening)

Note: In order for the other party to hear you, you must speak through the handset.

1Press [ Speaker ]

●Red light next to [ Speaker ] goes on; red light next to [ Mute ] goes on

2Place call or access selected feature

3Adjust speaker volume if necessary

●To raise the volume, press the right half of the Speaker Volume control button labeled [ ∧ ] ;

to lower the volume, press the left half of the Speaker Volume control button labeled [ ∨ ]

●If you have a display, it shows

SPEAKER L>>>>> H

(There are eight possible volume settings. On the display, one arrow is the lowest setting, and eight arrows is the highest setting)

34